This type S network system is used in the construction of industrial buildings, viaducts, bridges, overpasses, etc., they are usually made to measure, according to the work area to be covered.
This type S network system is used in the construction of industrial buildings, viaducts, bridges, overpasses, etc., they are usually made to measure, according to the work area to be covered.
Mounting
There are two ways to mount the S-type network:
- a) On the ground: Extend the nets on the ground and sew with a binding rope in such a way that there are no distances greater than 100 mm. Not held within the net area. Adjust the nets, pass the tying ropes through each of the meshes, and tie the ends of the dividing ropes to the perimeter ropes. Hoist the panels, already adjusted to the dimensions of the work and tie them by their perimeter rope to the certain anchor points, or elements of the structure. (The distance between anchor points must be less than 2.5 m).
- b) Elevated: Hoist the panels, already adjusted to the dimensions of the work, and tie them by their perimeter rope to the specific anchor points or elements of the structure. (The distance between anchor points must be less than 2.5 m). Once the nets are raised and attached to the anchor points, the panels will be joined with sewing rope, passing mesh by mesh and making knots every 2 or 3 meshes, so that there is no opening between cloth and cloth. more than 100mm Finally, pass the tying ropes through each of the meshes and tie the ends of the dividing ropes to the perimeter ropes. Note: To carry out the assembly of the nets it is essential to use the safety harness.
Safety Net Installation Near me
Building Construction Safety Nets Christchurch
